Darragh Broadbent

The SS495A datasheets state a response time of 3 μs and the DRV state a typical of 13 μs and a max of 25 μs. I believe either one is...

The sensors are closer to one another than you might think, in terms of linear range the DRV sensor beats the SS495 (only by 6 mT but there we are)...

You say we are working with a small magnet, they are quite potent and are quite close to the sensor. Do you know for a fact that we are within...

There are also other SKUs of the DRV5053, including ones with significantly higher sensitivity, in the realm of 90 mV/mT, but they become saturated at much lower levels.

It would be interesting to see what the raw values shake out to be during the calibration process.

Depending on what machine this is you need to set the nozzle diameter in the menu of the printer. I know on the MK3 it's in the 'HW setup' menu...

I think it might be helpful if you specified which printer you were using? It's currently working fine on both my MK3S and my Mini.