Collin Kidder

It is possible that hardware issues could cause it. Intermittent freezes after a long time are pretty much the hardest thing to track down. There are many reasons that something...

8 and 16 happen to be where the common baud rates are - 500k and 250k. And, both of those work. The rest are just kind of filled in to...

Yes, it works fine for me, I use it quite frequently so if there were a systematic problem I'd probably see it reasonably quickly. Still, I do have various reports...

Well, one thing you probably need to change is that you're allowing for two CAN buses but you only have one. Trying to access the second can bus is going...

My experience is that the wifi performance seems quite good on the A0. I'm employed at EVTV where we also make a "Due" form factor ESP32 board and it has...

Umm... Sadly, I don't remember. It's probably been 3 years since I tried to use an Adafruit BLE module with a GEVCU6.2. Hmm. What does it say when you enable...

Hmmm.. It seems to work for a little bit then fail and get stuck. And, it seems to be corrupting the lines a little bit. For instance, it should be...

When I asked about the firmware version I was referring to the Adafruit module itself, just to be clear. It sounds like you tried to do that with their Adafruit...

I finally got around to looking into this more thoroughly. I first tried with a unit of unknown firmware version (forgot to check) it did work. Then I tried the...

So, where does that leave you? Well, actually the first unit I tried did nothing because it was a UART version of the board. You see, there were many versions...