cochcoder

> I can't test properly because it's also causing overextrusion and spiderwebs:  Same filament, same settings on BambuStudio comes clean! So I can't trust my tests with OrcaSlicer. >...

I added the G-Code changes; it also seems that adding "role_based_wipe_speed": "0", causes the build to fail. Can you try without this variable enabled, just in case? > I've also...

Ok, it's in there now. I also upped the retraction speed a little, should the wipe speed also be brought up a little?

> 0.2mm file? Missed that, sorry

Are there any other changes needed to the Ender-3 V3 KE or is it all good?

> As for the wipe speed, currently it should be 80% of the travel speed which calculates to 320mm/s. Faster than that and the nozzle will tear off the prints...

> > I am a little concerned that this might be too much for delicate filaments, what is your experience with this? > > My experience is that it could...

> I haven't tested for a definite answer regarding this. However settings the wiping speed to 200mm/s should be safer but over-extrusion will always create issues regardless. I'll implement this,...

If there is nothing else you can think of that's needed. I'll go ahead and mark this PR as ready for review.

Should I try to add `BED_MESH_CALIBRATE` after the bed temperature reaches temp?