brvdboss

Bug: CNC 4-axis project: when opening a saved project, the STL changes size

1

# 🐞 bug report ### Affected Version(s) Luban 4.1.4 (current stable) haven't tested other versions yet. ### Is this a regression? (optional) Don't know ### To Reproduce 1. Create a...

# 🐞 bug report ### Affected Version(s) Luban 1.4.2 (current stable version) ### Is this a regression? (optional) Hasn't worked before ### To Reproduce Steps to reproduce the behavior: 1....

# 🐞 bug report ### Affected Version(s) Snapmaker Luban 4.1.4 (current stable, haven't tested earlier versions) ### Is this a regression? (optional) unknown to me ### To Reproduce 1. Create...

Release improvement: Can you also use the releases or tags for new versions of the firmware

9

A new release of the firmware is published and was announced on the forum: https://forum.snapmaker.com/t/snapmaker-2-0-firmware-updates-and-downloads/5443/12 (maybe through other ways like facebook too but I don't have a facebook account). But...

Start automatic calibration above the bed in stead of right behind it (move X &Y before down Z)

3

When you start the calibration routine, the z-axis moves down first until a level that is expected to be a bit above the printbed. The bed sensor however is located...

Z-axis misalignment: not fixed by homing

1

Hello, I ran into a situation where a pair of axis (z-axis, but I think it could just as well happen with the y-axis) got misaligned. While using the cnc...

Dual Extrusion: Bed leveling assumes fixed values for height

3

When using the dual extrusion print head, the firmware makes the assumption that the bed is beloz 50mm https://github.com/Snapmaker/Snapmaker2-Controller/blob/3150c90a17f5eccc3f1c078a7d13439d6a5e97ca/snapmaker/src/service/bed_level.cpp#L39 https://github.com/Snapmaker/Snapmaker2-Controller/blob/c92df5047555307b14c078fd3080636f9bf6727f/Marlin/Configuration.h#L1239 I think both defines have the same intention. When for...