britkat1980
britkat1980
> we could really do with this @dewet22. This is used in HomeAssistant so every HA update reverts it back to an unfixed version (i assume v0.10.1) thus each update...
OK, that makes more sense. GivTCP is officially supported by GivEnergy and I work with their Dev team on updates etc... It is an addon, rather than an integration, so...
CRC must also include the slave_address and use slave address 0x11 to function properly
The lib in my repo does work with AIO, but with one caveat. It doesn't yet get battery data, so you have to set the number of batteries to zero
Agreed, this should be removed from the command.py.
The modbus response from the GE invertors is not 100% stable, so it is to be expected that you will occasionally get these failures. The code you write to use...
The key to this is to work out what ThreePhase controls could mimic enable_(dis)charge_schedule and represent it in the same fashion, looks like they aren't in the portal.
This is an error in Dev Version of GivTCP, fixed in 716 (to be tested). I think it only happened when charge rate is set to Zero. Install 716 and...
I believe that predbat uses rest for reading data and that the rest config line you commented out was for control…?
Northamptonshire is a bit far away for me, but happy to try and get remote access sorted again. If you can get the vpn up and running