bodyhey
bodyhey
When you are in UART mode and set the motor in lowest gear (command "e0 f6 01 d7") and then give some resistance against the shaft, sooner or later the...
Dear MKS-Team, is there already a release date for the SERVO42C firmware version 1.2? There are two issues with v1.1, that should urgently be fixed: - The problem with the...
Dear team of makerbase-mks, [cricket2009](https://github.com/cricket2009) suggested, a new firmware for the SERVO42C will be released in february or march 2022. Some new features had been discussed to make the SERVO42C...
I have several SERVO42Cs but one seems to to be defect: when choosing UART mode, the stepper starts vibrating at 832 Hz and gets hot. It makes no difference, if...
Even in "lowest gear" - with the speed setting "0x00" the SERVO42C turns relatively fast (if you use it for animatronic): Could you implement some kind of "slow mode" command...
If you use the serial command 8: "e0 f3 00" to disable the coils (to move the shaft freely), also the output of the encoder doesn't change any more. That...
It would be great to have an UART command to drive the stepper to an absolute angle position. At present, you can just move x steps cw or ccw in...
I'm working with the Adafruit "Larson Scanner Shades" sketch - but on a larger scale with 1m / 144 LEDs. Even with the delay set to "0" the speed is...