BIGTREETECH-OCTOPUS-V1.0

BIGTREETECH-OCTOPUS-V1.0 copied to clipboard

Unable to update Octopus v1 bootloader

3

Hi, I'm unable to connect to the board and update the bootloader via STM32 programmer, I get the error "no debug probe detected". I'm trying to run Reprap on the...

dsplendido

Octopus v1.1 inconsistent or unreliable, erratic motor operation -- very fast & easy fix inside

6

I have been a fan of BTT products for many years, everything I owned that was BTT before worked flawlessly but after now three seperate boards im realizing there is...

zvonka

install of the BTT ESP32 install on Octopus v1.1 needed also....

6

install of the BTT ESP32 install on Octopus v1.1 needed also.... _Originally posted by @WesMcGee68 in https://github.com/bigtreetech/BIGTREETECH-OCTOPUS-V1.0/issues/109#issuecomment-1191590801_

WesMcGee68

Im using klipper to run my octopus v1.1. I updated the firmware and all of sudden the board stopped responding to the raspberry pi. (Was adding additional fan support at...

12Testing3

WiFi card ESP8266, ESP-07S Setup Instructions For Marlin Needed

6

Can someone point me to the instructions to setup my WiFi ESP8266 ESP-07S with the V1.1 board?

Aurawin

how/where to connect hall filament width sensor from klipper

1

Hi, got the octopus v1.1. now I have recreated the hall filament width sensor([link to hall filament width sensor](https://www.klipper3d.org/Hall_Filament_Width_Sensor.html)) and would like to connect it. unfortunately I can't find anything...

seebaer1976

More problems than its worth!!

3

The firmware BTT provides is not working anymore. I downloaded the firmware-F446-USB.bin, renamed it to firmware.bin and flashed my Octopus 1.0 board but Klipper keeps telling me I must be...

Cabinfourus

Unable to read tmc uart 'stepper_x' register IFCNT || Unable to read tmc uart 'stepper_z' register IFCNT

6

Hello, today I try to spin up my new BTT Octopus V1.1 board with sensorless homing , TMC 2209 in UART. I have jumpers in right position for all drivers....

JanSimancik

The standard Klipper/Octopus bed heater control Voron 2.4 with a zero crossing SSR results in flickering room lights that are on the same wall outlet circuit. In this klipper issues...

VoronManiac

Unable to connect to octopus pro board

8

I'm using Octopus pro v1.0, Marlin 2.0.9.3, and windows. I have been successful in uploading firmware but when it comes to connecting the board to my computer (I'm using pronterface)...

stewcop23