Britt
Britt
Looks like it uses the same pinouts as the GeckoDrive Gx540; so my Gx540 breakout board would be compatible. The revised PCBs went off to JLC for manufacturing about 18...
Grbl's g code interpreter does not support the % marker. UGS strips that out when sending the file to Grbl. To make it work from the SD card; remove the...
I haven't done much with the non-RAMPS configuration yet. I'm not even sure it compiles right now... Eventually, I will address that, however. The SD card does use the hardware...
I'm working on the documentation as I get time; and hope to have some new pages up in the wiki this week. The A and B functions of that key...
Hmm... how about a SCSI cable? Centronics 50 pin, IIRC... The signals are slow enough that I don't _think_ termination is going to be an issue...
IIRC, some lower quality cables - assuming that it was being used with only SCSI - skipped on some of the ground lines... so it would probably be a good...
Oops... wrong button. Not supposed to be closed yet!
You are probably already aware of it, but I'll throw this into the thread anyways... Technically, VGA uses a three-row DE-15 connector (also sometimes referred to as a HD15), not...
I have not had a chance to work on this since mid-January or so... things got busy. I'm hoping to get back into it soon, though. First I'm going to...
Well; I'll add it, but I do think that if it's at all possible having dedicated knobs (via 5k pots) is the better option - just because you can grab...