Britt

That's actually the exact DB25 breakout board I'm going to be using... except I got it off of eBay, not aliexpress. As far as signal integrity goes... well... the Mach...

Oddly enough, I've had better luck actually _receiving_ packages from eBay than on Aliexpress... I have no idea why, they are both coming from the same place (China). Perhaps it's...

Nice! One of these days when I have some time I'll have to send it to my 3D printer... (going to be stuck running a tractor all weekend, and I...

Hmm... I'm also thinking a differential driver setup might be useful. After I get the other PCBs tested and and gerbers posted; I'll see if I can cook something up....

Jog mode is currently triggered from the keypad; and the encoder button switches between jog increments (the increments available are configurable in `config.h`. I can add an optional (via #define...

> What about using long press on the encoder button to exit jog. The UI infrastructure isn't set up for that. Everything is done on key-down events, not key-up events....

Sorry about the delay; things have been crazy here. As mentioned in the main ReadMe, this does not support graphic LCDs (i.e, 12864 or other similar devices). > A RepRap...

I'm not going to accept the _pull request_; because I _think_ I need to tweak one of the settings (upload_port); but I will snag the file; do the adjustment; and...

Two options, depending on the exact hardware you have: 1: Have the grbl system output 0 to 5 volts pwm, and tell the inverter that it's maximum speed is twice...

I just realized something... I'm in the same boat! One of my machines (that's in pieces at the moment, but...) has a spindle that takes 0-10v, and I want to...