bdring
bdring
I am considering adding support for a local display. I am looking into hardware and wiring options that might make sense. **I welcome any suggestions.** I think this wired interface...
Someone suggested lava could be enhanced, so I added flow and growth parameters. Now the lava can flow at any desired rate and direction. It can also grow in size....
I have been working to lower the startup current so they more battery options can be used. The problem is almost entirely due to the servos doing fast moves at...
It has been noted that other countries use different coaster sizes. There is a not a lot of flexibility in the current design, especially going to a larger diameter coaster....
I have a few extra. [Driect message me on Slack](https://join.slack.com/t/buildlog/shared_invite/enQtNjEzNjMwMTA3ODQ2LTJlYjgxYzY1NmE1ZGI2OGQ0NmVmNWU3NzhmNmUwMjBjMTFhNjk1NGE5OWVhMDk0NmIzNTI4NGE5NTE2ZTVlZDE).
The most recent version of the board has a missing connection on the fan pin. To use a fan you will have to pick up a ground somewhere else or...
FYI: There is a new revision of the controller (V1.2.1). It only has minor changes and uses the same cpou map as V1.2 - I rotated the relay a little...
Sometimes my touch screen stops working and it requires a power cycle to fix. Is there anything that can be done in code to detect and fix the problem?
- Added a few more system params. - Add some log_errors to expressions.
set_enable should happen before arc_ok is checked.