120decibell

This seems clear enough. Could you submit a PR to add that to the community documentation?

That's actually a really good idea. Let me see what we can do.

3MF files contain not only the model but also all of the print settings being used by the creator of the 3MF at the time. Those print settings may be...

I still see unexplained duplicate files and parts with lots of unsupported overhangs that will need to be corrected before this PR is accepted.

The configuration example should not be named printer.cfg as that could be very confusing for newcomers. Please give it a different name, perhaps the name of your mod?

This bit ends up being an unsupported perimeter. I'd recommend making the chamfer bigger to extend all the way to the perimeter and making a 0.2 deep step forced bridge...

Otherwise it's a really great idea and execution, I hope the fixes can get done so we can put it in.

That's actually really close. All you would need is to make that extra piece 0.8mm (2 lines) wide. Then it would create a bridge to support the outer edge of...

Thanks for your mod! Is there any loss of Z capacity with this mod? If so it should be in the README. There only other note I have is that...

Been a bit, any updates?