Aaron Barton

How can I compile firmware for a V9 board board153v9k?

3

I have a Synthetos TinyG v9 board153v9k PCB, and I would like to put the latest g2core firmware on. Is this board supported as a target? Do I need to...

The jog buttons in Goko are not working. I am using it to control a TinyG.

"Failed to get planning buffer" when sending Gcode to TinyG with small steps

4

I'm running into a problem where when I send Gcode to a TinyG V9 (Othermill) using ChiliPepper and SPJS, and there are small steps in the Gcode (specifically that of...

Failed to get planning buffer" when sending Gcode to TinyG with small steps

1

I'm running into a problem where when I send Gcode to a TinyG V9 (Bantam/Othermill) using ChiliPepper and SPJS, and there are small steps in the Gcode (specifically that of...