avfoto

Hi, I'm reading my Voltronic Axpert VM III 3000/24 through hidraw1. But, at the end of the reading, the readings are like this: "Charger_source_priority":2, "Battery_redischarge_voltage":-170818477223837696.0, "Warnings":"100001000000000000000000000000000000" it is normal?

USB read working, but USB2Serial doesn't

3

I have a Voltronic Axpert VMIII 24V, when I read data trough hidraw0, my raspberry obtains data without any problem, but when I change the adquisition method to ttyUSB0 without...

Data refresh on InfluxDB

1

I've setup the mqtt.conf file to work with my influxdb container. Aparently works well, reads the data and put into the influxdb database, but... instead of doing this every 30...

After a few hours working perfectly, I had to restart the equipment that powers the esp32 that pipsolar has installed. It has not read from the investor again and the...

Hi. I've tryed to install weewx-mqtt in a new an fresh installation of weewx 5 and there is no /etc/weewx/scripts/wee_extension. The only way I find to install correctly is making:...