arkypita
arkypita
> I will change every G0 command to G1 slow movement command, so that the fast G0 movement will not misalign the laser engraver, yep S0 before every G1 when...
Loop G-Code commands is something that usually should be handled by the controller firmware (grbl) and grbl does not. LaserGRBL neither.
Thank you. This are some url definitions that I don't push on repository because I don't want fork share those links, I think I miss to push the empty definition...
It's an error that came from the os, not in my code, never understand cause. i suggest install/update microsoft .NET framework 4 Also can help: In LaserGRBL, settings, switch connection...
@vniacob any Idea?
could you attach generated gcode? .zip it and drag drop in github post.
I understand your request but it is too difficult to implement for the mode that LaserGRBL work actually.
Change USB cable with a better shield one. Https://LaserGRBL.com/faq
None of this purple message should be seen if communication is fine. They are position and status message, handled internally and normally not shown. If you see them it's because...
Same the errors (red dot) shown messages sent from LaserGRBL and not correctly received by the controller