anjok

The easiest way would be to write a known start, say OTTO, then 2 bytes of length, then the Len bytes of data and then either a CRC or simply...

It was very annoying to track the cause of the stalled prints down to this problem. All I did was not use the plug and instead just plug the printer...

OK, so the dev version of gphoto now has a flag `/main//status/mirrorup` (name subject to change). While it would be nice if the indi driver could support the logic outlined...

I'm trying to use the python SDK on Raspberry pi and have the same problem: ```(.vector) akrank@escapepod:~ $ PROTOCOL_BUFFERS_PYTHON_IMPLEMENTATION=python python -m anki_vector.configure -e [email protected] -i 192.168.0.123 -n Vector-U4B3 --s 0dd1b489...

Not sure if this is the right place, though... here's the script to create the `guid` when you have the certificate (which I couldn't get): https://gist.github.com/randym32/16bde0ce2dda841336e3f9a250cca009