Stefan Agner

> i've got an error saying that a Thread Border Router is necessary. This sounds like you did not synchronize credentials (see also https://www.home-assistant.io/integrations/thread#to-make-home-assistant-your-first-thread-network). > Something is weird with the...

> I understand that with Silicon Labs Multiprotocol add-on, the OTBR used is not the one installed in HA but an OTBR which is embedded to the add-on. Is my...

The border router list shown in Home Assistant is based on mDNS/DNS-SD `_meshcop._udp` service. Usually, the timeout is 30 min or so, so if the OTBR/mDNSResponder crashes hard, then it...

Uh, I am a bit confused, is that container running `mDNSResponder` and `avahi-daemon` at the same time :thinking: It does *seem* to me that something with the OTBR container is...

This PR essentially does two things: Bump to Gecko SDK v4.4.2 and enables the BT HCI support. Currently we avoid pouring more effort into the Multiprotocol effort as it didn't...

> Yeah, technically this could work with the older version of the Gecko SDK (4.3.x) but v4.4.2 proved to be a lot more stable for me (the uptime is now...

> Problem suddenly appeared yesterday between 20 and 21pm UTC+1, with no configuration change whatsoever on my side. Did the supervisor upgrade itself, or one of the dockers inside it?...

HAOS IP? Why would that be helpful? When AdGuard is installed, the default respnder is AdGuard.. So this would set AdGuard as reverse DNS resolver for AdGuard? Typically, the device...

> Does anybode know if the latest version which has just been released fixes the issue? It is 5.0.5. It seems not, at least the default config still picks up...

The network configuration has no WiFi mode/SSID/authentication information, that is why that stack trace is caused. Granted, Supervisor should handle this a bit more gracefully and send back an appropriate...