XiaofeiSunUCSF

> @MattPM > > > http://samtools.github.io/bcftools/bcftools.html#reheader > > This seems to be exactly what I needed, thanks so much! @ocqub I got the same issue. Would you like to share...

I got the error here LRPlot(res,datatype='DEG') Error: `order` should contain names of all sectors. In addition: Warning message: Since you have set `order`, you should better set `grid.col` as a...

> chordDiagram Hi XinYu-pumch, That works!! Thank you for sharing your code!

> Reply to dlmatera: > If you want to find the pairs in all of your cell types, just run my code below. > > deg_list=list() > for (cell in...

> Reply to dlmatera: > If you want to find the pairs in all of your cell types, just run my code below. > > deg_list=list() > for (cell in...

> Reply to dlmatera: > If you want to find the pairs in all of your cell types, just run my code below. > > deg_list=list() > for (cell in...

> > > Reply to dlmatera: > > > If you want to find the pairs in all of your cell types, just run my code below. > > >...

> > > > > Reply to dlmatera: > > > > > If you want to find the pairs in all of your cell types, just run my code...

> It depends a lot on your input VCF file. > > **Sort VCF file in the same order as the BAM file** is not always needed, but only if...

> ALL.wgs.shapeit2_integrated_v1a.GRCh38.20181129 Hi cflerin @cflerin , Yes! My ultimate target is to use freemuxlet to get the genotyping of human samples. Thank you for this good information. I will try...