William Adams

Just downloaded build 51 and spent the better part of an hour okaying libraries to run and finally arrived at: Warning: QApplication was created before pyqtgraph was imported; there may...

No, I never get a window --- it just hangs.

I managed to find: https://github.com/napari/napari/issues/1393#issuecomment-729134340 but not quite grasping what's involved from reading it --- what environment and where does this get set?

That worked! William -----Original Message----- From: Adam Urbańczyk To: CadQuery/CQ-editor Cc: William Adams ; Comment Sent: Mon, Feb 15, 2021 3:16 pm Subject: Re: [CadQuery/CQ-editor] CadQuery2 / CQ-Editor not launching...

Or, for the sample files A and B, note the endmill which should be used, what size stock should be sourced, and where the origin should be set relative to...

Worked perfectly! I now have Bowler Studio v 1.48.2 running on my MacBook (which is currently still on 11.6.5). Thanks!

Did have a failure on the notification about authorizing the GitHub connection: >Safari Can't Connect to the Server >Safari can't open the page "localhost:3737/success?code=acb9a61d80b78ad1ef87" >because Safari can't connect to the...

Just warding off the error would be great! The full feature support would be gravy, but I can wait for that. Thanks!

Thanks! This is working great! 

I would like the ability to write out coordinate information based on calculations which would allow a module to write out a G-Code command for making the equivalent cut as...