Warre118

I have the same problem with my new imou rex camera. In ``2022.12.9`` no sensors where reported. as soon as I downgrade to ``2022.11.5``, I get the ``motion alarm`` sensor.

Hi Are there any updates on this request? I have the same device installed yesterday but can't get it to work. From what I understand ZHA needs to send a...

Hi, Thank you for the quick response, your help is much apperciated. I made the necessary changes to the custom quirk, however, there still seems to be an issue with...

The warnings are gone now, but the device is still only sending the x25 messages. I also see the "no explicit handler" message at the bottom of the log. not...

Just double checked, but that looks ok. I copy/pasted the whole block of code over the old block, did a restart of home assistant, and re-paired the device. Just to...

Hi, @javicalle have you been able to take a look? I had another look over the weekend, but I can't figure out why the handle is not recognized. If I...

ok, I think I got the handle working, based on the logs below. However the device is still repeating the `x25` command, so the exepected response does not seem correct....

Thank you for the info. The LED does not blink, it is permanent on, and In the logs I only see the x25 command coming trough in the form of...

The message is repeated five times, then there is a timeout of 5 seconds, and then the TSN number goes up with one decimal, and the status number goes up...

Hi javicalle, That gives me the same error message. If I use the `TuyaNewManufCluster` , the handle is recognized, but now I get a traceback. I had to import the...