Turge08

Burning 2 fans due to wrong polarity brought me here . I'm not sure how I could've interpreted it any other way though...

It looks like you have 2 macros that override bed_mesh_calibrate

I hae accepted the merge request by @Dan-Ev which should address this issue. Update your euclid macros to the latest version and remove the BED_MESH_CALIBRATE macro from the euclid.cfg. Here's...

I can look into it. Looks like the 2 following commands are needed before and after: # Macro to perform a modified bed mesh calibration [gcode_macro BED_MESH_CALIBRATE] rename_existing: BED_MESH_CALIBRATE_ORIGINAL gcode:...

The location of the dt-blob.bin is wrong. It needs to go into the /boot/firmware folder: sudo wget https://datasheets.raspberrypi.com/cmio/dt-blob-disp1-cam1.bin -O **/boot/firmware/dt-blob.bin**

> I wanted to thank you very much, I tried everything possible for two days without success. Your solution worked right away, you should forward it to bigtreetech, because it...