SufficentMuffin

Okay I didn´t know that. But since BabmuLab not uses Klipper this would not work I think. Its just a suggestion for shorter and less interfering load line on X1...

Of course, please excuse. If you choose Bambu´s P1S with the 0.6 mm nozzle the Slicer will show the 0.48 mm layer height profile for it. This should not be...

Sorry if I confused you. I don't want to print with 0.48 mm layer height. I just wanted to point out that it's not correct that you can choose 0.48mm...

I can provide some screenshots later to make it more clear :)