Nitish Itankar
Nitish Itankar
> If you are still experiencing the werkzeug.urls ImportError.. , I was. Try this work around.. add the following sed command line in the Dockerfile just before the line that...
Thanks for the review. I will incorporate all of these suggestions.
Hi @ice0 I have worked on your suggestions. Please review it here: https://github.com/synfig/synfig/pull/3608
I tested this issue and was unable to reproduce the crash. My setup: OS: macOS Sequoia 15.3.1 Installation/ build: from source (https://github.com/synfig/synfig.git) Application Version: SynfigStudio-1.5.3 I could observe that this...
I observed that the ValueNode_Add is editable whereas ValueNode_Subtract is not. When a subtract converter is applied to a parameter, its value can't be changed(unlike the case when Add converter...
> Your PR fixes this issue and allows to change control points on workarea if they have ValueNode_Subtract converter attached, right? I like this change. Not yet, because I wasn't...
> Your PR fixes this issue and allows to change control points on workarea if they have ValueNode_Subtract converter attached, right? I like this change. This has been implemented.
Dear mentors, kindly do the needful for this PR.
> After the requested changes, please rebase to current master (`git rebase master` ), and force-push it here (`git push --force`). We like a beautiful and clean git history line...
I tried to reproduce the issue on current master with the same text. The improper rendering issue seems to have been fixed in later versions. Below are the screenshots for...