SketchThis

Ok that worked! I can now connect to the board and get "movement" in the DRO! THANKS!! However I'm still not getting physical motor movement. I know my bench setup...

> I'm successfully using g2 with a Due on a milling-machine for quite some time now. I could probably check and send you some information in a few days. (But...

Does that matter if I'm not using the enable pins on my stepper drivers though? Right now the way they're setup on the bench is that I don't need to...

Ok, I was worried that beyond the actual enable pins that the software looked at that setting... I'll continue to poke around at the hardware to see if I can...

@turboproc Ahh, so you can't connect a Due directly to stepper drivers? I have a test setup like this: https://photos.app.goo.gl/iEFASC9cyhFMiUmB7 Essentially the drivers have their own power supply. All I'd...