tinyogx360
tinyogx360 copied to clipboard
Ryzee119
Something I noticed when assembling the boards was that the A1 and A2 pins were not properly set, and thus the atmega was going into controller port 4 mode. This...
On my boards, the 3.3v regulator enable pin was tied to the Vout of the voltage regulator instead of the Vin of the regulator. This caused the regulator enable to...
Dear Sir Ryzee119 your project Tinyogx360 seems very interested i'm really want to try to build it , every thing seems good in the project file (BOM, PCB GERBER, FW)...
