Prusa-Support

Hello! Thank you for your idea and for sharing it here! We'll check together with devs if this can be of interest, we'll let you know in case of anything...

Thank you, also for the suggestion on the firmware side. Honestly, I like the idea but I'm not much concerned by the low-left position. I would be more concerned by...

Hello, thank you for the comment, sorry for intervening so late on this thread. Currently, the temperature threshold, on MK3-family, for Mintemp to occur, is 10 °C, 50 °F, for...

> I am unsure as to why this reported bug 4285 was removed So do us. We wondered that too and only now I realize the author may no longer...

> What comes first? the chicken or the egg? Our official Tech Support comes first. 🙂 No hardware or firmware-heavy knowledge required, and I'm glad to hear that the problem...

This case was rather specific and not based on the firmware but on a hardware problem solved via an idler motor replacement. Please allow me to close this issue and,...

That was the solution for the author of the issue, as a result of the troubleshooting session. The solution may not be replacing this or any other part, or **not...

Thanks for your feedback. This issue has the developers' attention. Michele Moramarco Prusa Research

> I only load the filament after mesh bed leveling as a workaround to the oozing... Keeping the filament very dry should make a noticeable difference. Other workarounds may be:...

> What the heck does that mean? I know... The "heck" is intended to avoid other problems, and I'll try to clarify based on what I learned but I'm afraid...