Cael Magner

See #81. I was able to get it to work /w STM32 Cube programmer.

https://gist.github.com/NotAFood/6d864166c7a239ca0f35fb0cd4a2a3bc Not an official fix but I was able to write a Jinja2 template to emit XML SOAP to interact with a Wemo. May not work if Wemo (has /...

Yes. I've tried two of them with the same result. I know it is reading the card because it will accept a boot loader file from it.

I bought an ST Link on Amazon and was able to flash the board over the SWD port using STM32 cube programmer. Use 0x0800C000 as the address to flash to.

> @NotAFood, can you say more about how you connected to the board? Were there any jumpers that needed to be set? > > I'm currently seeing STM32cubeprogrammer spin forever...

Yeah I eventually had the problem too. I couldn’t get it to work again and ultimately went with the more user friendly Fystec S6