Mrnt
Mrnt
Awesome! You can invert the Z axis in the settings by going to Settings>Printer Profiles: either create a printer profile for the Dreamer or if you only will use the...
Just to verify - are you sending your prints to OctoPrint using the "Upload" button (and then selecting the file in OctoPrint and printing, or are you using the "Upload...
"Upload to SD" should be just the same as sending the file from FlashPrint to the printer - are you creating the file in FlashPrint or something else?
I have not used OctoLapse, but I assume as you said it injects gcode to move the print head out of the way before taking a picture. In which case...
The left button uploads the files to the OctoPi's memory (ie the flash card on the Raspberry Pi), and they will then appear in the list of files in the...
Sorry for the delay in getting back to you. re upload to SD: If you have a sample file that you cannot upload to the SD card can you upload...
Please upload the file so I can test with it, thanks!
If you upload to the address card using “Upload to SD” the file should go straight to the SD card and you should just see printing progress type messages in...
If you can upload a fresh OctoPrint.log captured during an SD upload that doesn’t print it would be helpful.
Yes there's an sd card embedded on the control board of most of these printers so when you connect using FlashPrint and upload a file it goes onto that internal...