Mrnt
Mrnt
Sorry for the delay in responding! What printer is this? It is hard to say what is going on from the snippet you posted - is there any more temperature...
1) > However if I start a fresh sending the G-code from Simplyfy3d to Octoprint the bed is at the wrong height. Is that after turning the printer on or...
@Colboto many thanks for the video - it almost looks like it is homing the z axis. Since this is happening when doing the load and print (vs upload to...
@G7KXZ , @Colboto can you indicate which version of the Dreamer you are using?
@Colboto if you can also get a debug log from the plugin when printing acrylic.gx direct to the printer (just needs to be the beginning of the print where the...
@Colboto - Mostly trying to determine if you have the original Dreamer or Dreamer NX just in case there are some firmware specific issues. A lot of the early printers...
It sounds like the Pi is correctly connected or you would not get the message you are seeing. The message is generated before the Pi has got as far as...
You can upload the file here, though you would need to fetch it from the Pi with sftp. If you can’t figure out how to do that just copy it’s...
does it actually look like: ``` SUBSYSTEM=="usb", ATTR{idVendor}=="2b71", MODE="0666" ``` or do you have the ^x^X at the end like what you pasted above?
You need that last quote mark after 666 ie: ``` SUBSYSTEM=="usb", ATTR{idVendor}=="2b71", MODE="0666" ``` do you have that? And I think you need to reboot the Pi after you make...