Mark

Same here. It should be marked as offline, not fail setup.

This would be useful to have. I'd always assumed the VSTi would do a high-quality resample internally, but the difference is definitely noticeable in the samples provided. In addition to...

FYI, for those in the XG world, to match closest to the MU50 hardware, the output frequency should be 44,100KHz. See the notes on https://github.com/mamedev/mame/blob/master/src/devices/sound/swp00.cpp, which is the renderer used...

Actually this might be more important than I thought - if I default to 32000 for GS and then swap to XG, running the XG soft synth at 32000 actually...

Is it that the CPU either use its synchronous serial hardware or handle each clock edge via an interrupt? The control-panel MCU is the sole source of the clock (CPSCK),...

A thought while the part number and frequency are confirmed - perhaps INTA isn’t a separate “slow” or pulse-width detector i.e. it just sees the same schmitt-cleaned CPSCK edge that...

Hmm, this is probably at the limits of my expertise, but my understanding is that R3/C2 only slow the CPSCK edge going into the schmitt input - they don’t create...

> I'm not entirely sure, but these routines seem to set it up for either 250kHz or 62.5kHz If CPSCK were generated by the TLCS-900, R3/C2 would make no sense...

> Note that SCLK1 is the same as CPSCK, but _not_ the same as INTA. SCLK1/CPSCK is the clock signal _before_ it is processed by the low-pass filter (R3/C2) and...

I have the same problem on HAOS 16.3 on a HomeAssistant Green. `[13:28:25] ERROR: WireGuard failed to establish a connection. [13:28:25] ERROR: wg-quick output: [13:28:25] ERROR: [#] ip link add...