Madcamper

The workaround cp2004 performed was on a fresh install. If you are trying the workaround from 1.8.2 > 1.8.3, it won't work. When I performed the workaround, it downgraded me...

My phone is not rooted but ssh'ing into the phone via enabling it in octoprint, I don't have a "udev" folder under \etc\ - not sure if this is because...

Unfortunately I'm on a prusa and don't use custom firmware with it but hopefully this information will be helpful for anyone coming along and/or the dev to maybe pinpoint somewhere...

This has been fixed by backing up and re-installing octo4a. I think it had to do with my octoprint version 1.8.7 and python 3.9.5 combo.

The steps I took are as follows: 1. Make a backup of your octoprint config through the GUI and save it to your computer 2. On your phone, clear the...

I too have noticed a similar issue. Mine is along with organic support coming from the build plate up onto the model. As it prints through the hole, it then...

Doesn't appear to have been fixed, at least in my instance. This is a bird feeder base with a few drain holes in the bottom. The supports are for the...