LoganFraser

There's a touch focused fork of iosender that has more direct support for portrait. My machine is currently in pieces so I haven't looked at it in detail yet but...

Didn't mean to close it. ;)

I'm just using one of the portable USB-C powered 15" touchscreens available on Amazon. It works well enough.

Ah. You mean do it as a sequence of operations. Maybe I can turn that into a macro then

Basically, the PrintNC group runs M6T99 in to "pick" the probe, and touch off and set the tool offset reference. But if a reset occurs, the initial TLO is lost...

I'll see if I can get a teensy environment setup for compiling tonight and give it a test. Thanks.

That depends how big the flight controller pcb is, I'd imagine. Do you have a link for it?

There's someone working on a GY-521 option here: https://github.com/sb-ocr/diy-spacemouse/issues/5

You have a C:\ then most of the rest are /, then more \, that's probably the issue.

An additional request - add support for a TS.macro (toolsetter) so any calls to measure tool length use this if it exists, same as the function of TC.macro. helpful if...