KarstenBr

I just checked the entities of my boiler: selflowtemp is correctly named “Sollwert Vorlauftemperatur” as it is indeed the target value computed by the boiler dependent of the outside temperature...

@MichaelDvP When testing SW 3.6.3-dev6c this week, I have recognized that the beforehand missing 4 hpinput entities have been activated again - thx. Therefore I also checked their proper function...

ok, then I would propose to instead use logical/function input states as entities: so, instead of input2 (in my case), 2nd bit of 1st byte is „inhibit warmwater“, which is...

ok, I will look into this during the next weekend

@MichaelDvP I did now some experiments with the input configuration: - independent what had been configured for input2, the electrical switching of this port did always change the same bit...

@MichaelDvP Thanks for adding it to 3.6.3-test7a. As soon as I have a state change of EA0 I will check the correct behavior of the new entity for EA0. Nevertheless...

The heatpump did just now activate EA0 and this was properly reflected in hpEA0.