Jim-bee

How to use Wire1

2

I am trying to get the 128Kbit fuji fram working with your library but I am on Wire1 bus. In your library.cpp file I have tried to change Wire to...

Motor slammed into the side of the printer - servo board does not work anymore?

4

Hello, The motor with servo board installed was working fine. The motor on its own changed direction and the carriage slammed into the side of the printer. It stopped there...

Circles are not round

11

Hi, I have another issue / question. In my testing (using 64 steps) doing circles the circles are not round when using your servo board. If I do the same...

Signal Timing

2

Hello, I have checked the manual and can not find this information. Can I please get the signal timing for: 1) Direction change minimum pulse width (microseconds). 2) Step pulse...

I am using a buy display 2.8" SPI interface for the screen and using your tft_touch library to run the touch panel. This is attached to an Adafruit GrandCentral M4...

Hello, Can you please add in SPI DMA capabilities to your library. Thanks,

Can you please add in the other fujitsu fram sizes to the library.