Jim-bee

Hello, Thank you for your reply and information, good to know you have the protect function. I wish the protect default was enabled. I would like to try to fix...

HI cricket2009, I tried enabling the "Protect" and tested the motor does not stop it still sits at the end stop vibrating. This does not seem to work as you...

Hi cricket2009, I tried your settings and they do not seem to help with the circles. My test is using a pen and I draw 3 different diameter circles in...

Hi Pastitas, I have found that a stepper motor maybe spec'd for NEMA17 size but manufacturers in China the rear end cap shaft opening dimensions are never the same. Even...

Hi GeorgScha & Ingrow-Cloud, Good the see I’m not the only one seeing this issue with circles. I also tried using the 42C board and disabled the servo mode -...

Hello, Thank you for the timing specifications for your servo board. Best Regards, Jim > On Feb 14, 2022, at 12:20 AM, cricket2009 ***@***.***> wrote: > > > > —...