JamesH1978
JamesH1978
We have the need to do a full sync of azure, unfortunately the super massive statement created causes issues on our sqlserver 16.0.1000.6 installation, Execute scheduled task: Sync users with...
### Is your feature request related to a problem? Please describe no direct problem it's more a quality of life thing those planning to have multiple steppers with these drivers...
It has been noted a couple of times that this file states to only use the bare macro names in the slicer. Which is fine if you want to set...
With the addition of usb support would it also be possible to run this over CAN with a cheap transceiver? As the rp2040 can drive can over any 2 gpio...
Mounting
Good afternoon, Do you have any tips for mounting this? I would assume it has to sit rigid inline at the extruder entrance, As I can see issues with the...
Small PR to clarify and add some points about exclude_object and properly defined gcode being needed for adaptive meshing. Also some extra info in Slicers.md to clarify other slicers, and...
From some troubleshooting on the klipper discord, noticed that a manual install has the location of the python module in the root and not in the src directory. Thanks James
It has been mentioned that the offsets have no bearing on the points probed in quad gantry level, cited by user bjkroll on discord, both on beacon using its module...
This is a PR to add the steps needed for bookworm installations to enable the can0 network for host hardware Thanks James