Sascha

Just as an additional confirmation that V1.20l fixed the "Unknown MCU command" message on the ME81H: I had the same issue (error message) with V1.20k. Updated to 1.20l and the...

I do have the same issue: The clock of my thermostat ME81(A)H / firmware 1.20l is not set correctly via ntp. Reads/writes via MQTT are working. My NTP settings are...

Hi, I just updated to version 2.6.3 today and had the same issue (error message) as @ambarusa After checking that everything else is set up correctly, I thought the plugin...

> I'll address message types when I get home in a few hours, but I wanted to quickly mention that I do want to also confirm message integrity, because LoRa...

As far as I remember the SX126x/SX127x chips are only operating in half-duplex mode. That being said, when sending a package back from the gateway to a sensor it is...

> Replacing the float has been a long-term goal, but they're just so convenient. It's been off my radar for a bit, so let me think about it. > You...

Sounds great! 👍 Just a small but important notice at this point in the development: I would not name sensors "nodes". Node is the subordinate concept of gateway and sensor...

I am not too familiar with ESP-NOW but after a short reading of the ESP-User Guide https://www.espressif.com/sites/default/files/documentation/esp-now_user_guide_en.pdf there it is said that Combo is one of four roles which can...

[START TLDR] Naming conventions should be representing what is done within the object - therefore do not use node, combo or biod on the base level. Bi-Directional communiciaton (combo mode)...

> > (I guess our node can be a sensor or gateway or whatever node is beeing added to the network?) > > No, it will never be a gateway....