GregValiant

Thanks for the report. The bug I see here is that the Skirt/Brim extruder _must be explicitly set_ to Extruder 2 when that is what you want. Whether Extruder 1...

The Preview Slider has two white circles. The one at the top will lower the layer down to the "layer of interest". The bottom circle can be slid upward to...

Thanks for the report. This is expected behavior. With no actual "model mesh" on the build plate Cura considers that there isn't anything to print so it takes a pass....

@HellAholic Here is the model file from the OPs' post on the UM Forum. [UM2_test.zip](https://github.com/Ultimaker/Cura/files/14466227/UM2_test.zip) This is in 5.6.0. The aberrations are there. I don't know that they can be...

Thanks for the report. I agree, that doesn't look right. It might be a problem with the combing mode "Not in skin". In the "Travel" section, changing the combing mode...

I tried this again with 5.3.1 and it sliced at 100% scale but not when I scaled it up. It sliced in Cura 4.13.1 at any 100% and at 200%...

Thanks for the report. The 5.7alpha version is not a production version so there will be issues. Please go back to a stable version and see if the problem is...

Thanks for the report. There have been a lot of problems reported with slicing in Windows 11. I'll mark this as a duplicate. I didn't have any trouble slicing it...

The problem sort of appeared out of nowhere. I don't know if it will be fixed for 5.7. I do know the Cura team has been working on it. I...

Thanks for the report. It isn't clear what you were doing when the warning came up. Can I assume that you successfully sliced a model and created a gcode file?...