GregValiant
GregValiant
Thanks for the report. The visibility of the setting is dependent on the setting in Top/Bottom "Top Surface Skin Layers". If that is set to 0 then the pattern is...
In Cura, go to "Preferences / Configure Cura" and in "Viewport Behavior" are "Zoom towards mouse direction". Is that enabled? ("Zoom toward mouse direction" only works when you are in...
Thanks for the report. This bug has been reported numerous times so I'll mark this as a duplicate. The model appears to be free of errors. You can try simplifying...
Thanks for the report. Like a slice, it is very thin.
With the model loaded in Cura, and with Cura set up and ready to slice, use the "File | Save Project" command. Put the 3mf file in a zip folder...
Without a Cura "Project File" I can not investigate this. I don't know what a "*.blend" file is but Cura will not open it.
Without a project file or the model we can't really tell what's going on. Have you tried moving and/or rotating the model on the Cura build plate? Sometimes that can...
I don't have permission to download from there. Can you zip the file and post it here?
Thanks for the file. There are 4 small errors (one at each corner of the base) according to Mesh Mixer and 3D build didn't find any errors. This model should...
I tried again and I can't get it to slice at any scale in 5.2b