Giuliano Zaro

I read somewhere that boot log messages may be disabled on esp32 and not on esp8266, but I forget where I read it

@probonopd this should be addressed by version 2.0. Only thing missing is L. Cura gives info in gcode but I don't know if all slicers does this and if they...

M73 is still supported if printer report capability to handle it

all of that depends on firmware...if firwmware supports them then it is supposed it will do something on LCD

> Do we need to reset the printer mainboard using its RESET pin? (It is broken out on the ICSP header) For mega2560 answer is yes, this is why Soc...

> avrdude: Recv: . [14] avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0x14 That's a little bit weird...received 14 and expected 14..

> avrdude: Send: A [41] . [80] [20] avrdude: Recv: . [14] avrdude: Recv: . [10] avrdude: Recv: . [14] This is a wrong answer. It should respond 14, value,...

> jeelabs/esp-link#50 it seems like you get a 14 10 from previous query. because afer it you really get 14 3 10..Check if avrdude may increase timeout before resend command...

It seems promising...

Perhaps I think printer still print sent code