FreeJoy

FreeJoy copied to clipboard

Run an LCD as well as the joystick?

1

Just a Question not an issue, I'm building a bus simulator, and have a few items that have LCD's in them, a program extracts the data from the bus sim...

gazz29

More question then problem

3

Good morning, more than a problem is a question, would it be possible to use a rotary encoder instead of the normal potentiometers? and if so, what difference could they...

pipes80-collab

Cannot connect on linux

12

[30058.419960] usb usb1-port2: attempt power cycle [30059.071876] usb 1-2: new full-speed USB device number 35 using xhci_hcd [30059.072142] usb 1-2: Device not responding to setup address. [30059.280137] usb 1-2: Device...

e-wartal

Use the AS5048A magnetic absolute position sensor as a multi-turn steering wheel

2

This is a great way to build 900 degrees multi-turn steering wheel to drive Euro Truck Simulator 2. Configuration file stays the same. Support that AS5048A act as multi-turn steering...

dr-milos

Device not showing up in Windows after PC power on

3

Hi, I sometimes have an issue - I leave the wheel plugged in the USB when PC is off, when I turn it back on, the wheel (Freejoy) doesn't show...

p33t-r

Not working on X570 Chipset

5

Hi there, I've been having an issue with setting up an STM32 with this, I was able to flash it with STM32 ST Link however, when using FreeJoyConfiguratorQT to set...

spookeo

It would be useful, given the number of inputs, to be able to report two separate gamepads to the OS. Many applications require two physical (or virtual) controllers and freejoy...

retrorepair

Analog Sensor (Question)

1

Hi! I'm working with a hall sensor. I'm trying to simulate a hand brake. RY Axis starts at -21,500 instead of -32,767 steps. Is there a way to correct this...

steveax79

Feature Request: SBUS output

1

Hi, Thank you for creating this great tool. It would be a great feature if FreeJoy had SBUS/PPM output. Thus, we could make our own controllers for RC devices like...

ferdicakmak

test that the axes that are not enabled cannot be turned off, they are always displayed on the interface that has already started

1

Hello I found in the test that the axes that are not enabled cannot be turned off, they are always displayed on the interface that has already started; For example:...

yzhanping