FreeBear-nc

> In HA I would then publish to mqtt { topic: "hasp/panel1/weatherforecast1", payload: theimage }. The image format should be png or whatever OpenHASP can handle, encoded in a standard...

> As for the use case: I have developed a modular system with machine automation on my mind. As a HMI I'd like to use a cheap ESP32-8048S070 display, connected...

It _might_ be that the touch driver chip is reacting to electrical noise and generating an interrupt. Been digging in to the GT911 programming notes, and I see a couple...

Hacked a few lines of code to read the config registers inside the GT911 chip. In the process, learned a little... My trivial little hack causes openHASP to crash &...

Tried adding a short bit of code to openHASP to modify the relevant register in the GT911 chip during setup. Unfortunately, this addition triggered a panic and infinite reboots. As...

Had a spell of phantom touches on my Guition display. Didn't get round to uploading my code, and the events haven't reoccurred. Intermittent ghost events are a pig to diagnose...

@smcgann99 Catch me on Discord over the weekend to discuss options.

Pushed three firmware images to my repository. You'll need to use esptool to upload them to your board. Once loaded, do a reset and let it run. Then upload the...

> Have you installed one of the values to your screen, if so which ? Tried 6 and 7. But I've only had one evening of phantom touch events, and...

If you only ever used a 1:1 aspect ratio, it would never be noticed.