Fred7421
Fred7421
I figure I should give back a little if I can. Plus added versatility would be nice. As the rules stand now, you can only associate the settings for one...
I guess most of my wish list is re-inventing the wheel. The current rules/relay choices cover a lot of what I was thinking. I was going for a 'per relay'...
Basically, If I eliminate all the dump resistors and replace them with a two pin connector (out) and a flyback diode across those terminals (the coil), all should be good?...
Yes, an external load would be monitored but I would still need to monitor the temperature of the cell module itself. What about leaving the pwm as is and running...
I'll look into the MOSFET idea and see if I can come up with a simple circuit. Thanks Stuart.
What frequency am I looking at?
Ok, and the max current through the dump load is 940mA?
I think I've got it worked out, How do I stop the dump load signal from turning off for a blip every 12 seconds? Is that in the code, (edit:...
It's unconnected to any controller, just power to the module. The module is 4.0 code version: 2021.02.24.12.59
Well I've got the module connected to the controller (working), I've got the relay connected (working) and every 13 seconds the red led indicating the dump load blinks once, it...