EnragedRabbitProject
EnragedRabbitProject copied to clipboard
EtteGit
Hi, I was printing a multi material benchy and it ran into a problem after ~140 layers (of 245). It looks like the print was not paused while ERCF was...
Hi, I was printing a multi material benchy and it ran into a problem after ~140 layers (of 245). It looks like the print was not paused while ERCF was...
The stealthburner is already release the RC version for a few days ago ,so may i ask when will the EnragedRabbitProject project team will release the clockwork 2 version filament...
In the current version of the STLs, the encoder cart has a place for a bearing tension screw on the bottom, however, that information is missing from the ERCF Manual.
I have been using the ERFC for a few weeks now, and have gotten most of the things worked out. I have an issue with the servo (MG90S) not engaging...
Took the updated STEP file, exported mesh to STL. Re-oriented part in SuperSlicer.
This pull request solves the issue with #110. Rather than to extend the geometry, I modified the angle in place, and created a lower foot to lessen the bend in...
The reference to **rail** isn't required in the code, removing this reference allows us to further remove the unused endstop pin from **gear_stepper** in **ercf_hardware.cfg** FIXES #96
ok - got this a couple of times now MCU 'ercf' shutdown: Timer too close This often indicates the host computer is overloaded. Check for other processes consuming excessive CPU...
I came across this idea when working on my ERCF code. Hopefully my proposed solution could improve the overall robustness of the selector motion. The idea is to mimic the...
