EnragedRabbitProject

EnragedRabbitProject copied to clipboard

The latch on the CW2 has changed and there are some mods to the main plate and motor plate needed to accommodate this. No changes outside usermods/CW2_with_ECAS_and_optional_sensor.

GarthSnyder

Dimensions of completed ERCF

1

Hi, do you happen to have the dimensions of the ERCF documented anywhere?

psharma04

Discord Link inactive

1

The discord link in the ERCF Manual is expired.

TheBiz73

Is there an Assembly Manual for the ERP?

1

Hello, I would like to know if there is an ERP assembly manual.

MADISON948

What connects the ecas insert block to the ERCP sliding arm.

1

The stp looks like a 1.75x30mm dowel of some sort. Is this intended to be a printed part or a purchased part and what material?

Mherboth1

How to adapt for other extruders? e.g. Microswiss ng.

3

I have thoroughly read through the instructions on this, however I am finding it difficult on how to adapt it for other extruders. I have a Microswiss ng, and it...

Blake1532

Is there an ERP discussion group in Spanish? Since I must use google translator and it is not the same as knowing English.

MADISON948

support

2

is there a support group or so where we can ask questions

cotthemh

Hello, the "M104 T1 S230" gcode creates error "Extruder not configured"

Tathar

unfortunately the BoM is not included in the files. It is only accessible through a google service. This is problematic in terms of privacy and as a dependence on a...

cofilippo