Dronek
Dronek
> I don't get this, is that only on planes with a rudder ? No, I have been experiencing this on my first and second flying wing with inav. I...
> It's most evident if the turn is slow and long and the plane sinks a bit during the turn. In such a condition the resulting absolute g-force can quite...
> isn't it easier just to have that calibration stored as a constant, and to have it revert to that the moment you let go of the sticks? This could...
> Situation is always the same. When he hold roll for a long time IMU roll angle calculation have gets huge drift and think that it is leveled.... I can...
The target inav_2.2.0_MATEKF411_SFTSRL2.hex allows to use the LED pin as well as the ST1 pin as two softserial ports. However, they are both TX only, as far as I know....
I built an inav 2.2.0 FW from the development branch where I assigned softserial TX to ST1 pad and softserial RX to LED pad. Not sure if it works as...
> @Dronek have you tested in flight? I'm asking for #14 It has been quite a while since my last flight but as far as I recall nav radar never...
I noticed the same issue with POD 2.0. There is no practical way to turn off the WAH once activated other than power-cycling the POD. It also happens, when I...