Alain Turbide

Ok, i've pushed a change that adds the beeps. Still a work in progress for now. A few other changes in the back end so hopefully nothing broke.

Weird one. I don't get any timeouts or disconnects when arming or disarming. Looks to be related to the partition1msg perhaps. Too much traffic sent? I've seen that sometimes. You...

Interesting. I can't duplicate the issue but I've pushed an updated version that disables the partition messages and some debug prints to see if it resolves the issue. Try the...

If it is too much traffic causing the issue which I suspect it is since I dont' see the issue currently but have seen it before, you can reduce the...

Well, I doubt using transistors or mosfets will change anything. The resistor dividers have minimal impact on the bus since they are very high value. But then, the only way...

Just to clarify, no matter how many devices are on the bus, the data frequency will not change at all. No device sends at the same time. They all have...

set DSCkeybus->debug=3; in the yaml and using arduino serial monitor at 115200 baud and the esp connected via usb, I suspect there is some heavy traffic causing some delay but...

Fair enough. Which branch are you using for your code, master or dev? I will post an updated version that prints more info on the ha console. Yo will need...

FYI, I posted a new update to the 'dev' branch that fixes an issue with module handling that could cause the delays you were having.

FYI, i've added new features in testing to the "new" branch. A couple of them is event publishing. This includes arming and disarming with which access codes. You can have...