Mick Percy

Similar issue here... "can't build hal pin 18: embd: your host ": ARMv7 Processor rev 5 (v7l)" is not supported at this moment."

Implementing it is easy. Implementing it so that the safety issue is managed is something altogether different. To mitigate the safety issues you would ideally need to undertake an FMEA...

I started to write a reply before, but then decided I was waffling so didn't post it (it was late last night). The safety stuff is not trivial. Here's the...

"Project is distributed as GPL-2.0 as far as i can tell, which strips the creator of any liability for failures/damages." Yes and also no. :D The GPL does try to...

Good to see that this is planned. ~~I've been looking for a solution for auto bed levelling that can be integrated into Grbl_ESP32 (which uses ESP3D)~~. As you may know,...

Ahh okay. The[ GRBL_ESP32 Wiki](https://github.com/bdring/Grbl_Esp32/wiki/ESP3D-Web-UI-for-Grbl_ESP32) states > The ESP3D-WEBUI project has been modified for use with Grbl_ESP32 by Luc of luc-github Is that not the case? The proposed change mostly...

I think you are getting confused. I have edited my orignal post to clarify. Please re-read it. I am asking about integration into ESP3D-WEBUI for auto bed levelling. My comments...

The cnc-kt-ext plugin documentation seems to imply that it is updating the entire file, not modifying streamed Gcode commands on the fly. The following is from the [README file](https://github.com/kreso-t/cncjs-kt-ext/blob/master/README.md) >...

> Everything is possible, it is just a matter of effort that need to be done Absolutely. Sage words there. I'm going to make some time and work through the...

That's great news. Any time line for this? Yes I agree. I'm really not too sure on the millisecond requirement. My current wavemaker (single power head) just has a dial...