Dave Holmes

Also forgot to mention I checked my firmware configuration_adv.h file for ARC SUPPORT and this is what it shown: #if DISABLED(SLIM_1284P) #define ARC_SUPPORT #endif #if ENABLED(ARC_SUPPORT) #define MM_PER_ARC_SEGMENT 1 #define...

> Thanks for posting your issue @Daveholmes05! This is actually a well known issue on older versions of Marlin that don't have additional arc settings. Your version is missing some...

Thank you very much for the additional info. I will try the maintenance candidate and see if that works. I'll let you know how it goes.

Unfortunately, the maintenance candidate made things worse. It's still printing the sharp angle rather than the curve but now it's pausing at two spots and causing a big blob. It...

Sorry, what's the best way to get that to you? Where do I collect what you are wanting?

I think I did this correctly. I created a new file from Cura that was only about 4 layers tall to have a quick beginning and end print for you....

So is there a way for me to enable arcs for this firmware or do I just have to try and flash to a newer version?

OK, so I should just try this latest version then? https://github.com/MarlinFirmware/Marlin/tree/2.0.7.2 Do I need to check anything to make sure arcs are enabled when I flash it to a newer...

> Should look on Th3dstudios.com website. Their latest versions support arcs on creality printers quite well. Yeah, for some reason I thought I could only use the 8-bit version because...

> @extesy As usual, i can not reproduce this issue in my environment. Did you manage to do so in yours ? > > BTW, there are (at least) 2...