André Kjellstrup
André Kjellstrup
build_error: No rule to make target 'bootloader_only_binaries', needed by 'copy_generic-pc13'. Stop.
``` ~/prog/STM32_HID_Bootloader/bootloader/F1$ make generic-pc13 CLEAN arm-none-eabi-gcc (GNU Tools for ARM Embedded Processors 6-2017-q2-update) 6.3.1 20170620 (release) [ARM/embedded-6-branch revision 249437] Copyright (C) 2016 Free Software Foundation, Inc. This is free software;...
Most of these chargers does output a serial stream for monitoring. I would like to be able to control them over serial protocol. Like: select Li-po , current, cell count,...
All necessary documentation is here: https://drive.google.com/open?id=1PoXcpEmy-p9_TOGIYLHb5D5GCp9P6Eze executed on GRBL1.1h (current release) Whatever I did as a new pycam user, something is wrong. Please see "expected motion.ogv" - the toolhead starts...
On arduplane, it does not help to switch mode. Once a mission is completed, Auto mode does not reset back to first waypoint. Please add an commend to reset(restart) AUTO...
After a auto mission is completed, "waypoint 65535" is announced. That could be replaced by "mission complete" of "mission ended" or something like that.
please add voice feedback for when good GPS fix is achieved.
Please skip alarms like "~warn radio, ~connection lost" if APM status == disabled. Today, after landing, disarming, - then disconnecting power from aircraft, those alarms are spoken. Of course, some...
Every time I use AndroPilot, I start off by zooming in, a lot, on the map. Please,once decent GPS fix is achieved, switch to a zoom level that displays no...
Please add the option to tune a selected value by bigger and smaller steps (percentage) Alternatively, add options to select what is tuned by CH6 - basically what MP does.
For arducopter, it's pretty important to have correctly calibrated magnetometer. Please add an option to start calibration.