AlexanderLeporiday

I've just run into this same issue. Writing my own home automation script and I can open and close the curtains but I can't control just the left or right...

It might help to look at #22516 as this issue has been reported multiple times. The solutions vary from setup to setup. Perhaps the issue is with device 0xC1A7 (49575)

If you update to the latest firmware you also need to update Z2M to a newer version that has the new converter. You then need to reconfigure the device to...

My apologies. I was getting notifications for this topic from GitHub for some reason. It seems someone linked it to the Z2M topic where the firmware changes were discussed in...

EGLO_ZM_RGB_TW missing from [awox converter](https://github.com/Koenkk/zigbee-herdsman-converters/blob/master/src/devices/awox.ts) Likely should be part of Awox 33943/33944/33946 as this is an RGB light and not a colour temp light. However EGLO_ZM_RGB_TW has been added to...

If you go to state do you see the brightness value reported there? If you check the Zigbee2MQTT logs, after making a change to the brightness level, do you see...

I can see you attached a debug log and from what I can see the following: > [2025-01-20 11:00:14] info: z2m:mqtt: MQTT publish: topic 'zigbee2mqtt/Downstairs Bunk Bed Light', payload '{"brightness":254,"effect":null,"identify":null,"linkquality":7,"power_on_behavior":null,"state":"OFF","update":{"installed_version":587753009,"latest_version":587753009,"state":"idle"}}'...

If you want to add this device to HS2IRC then I believe you need to add IRControl2-EF-3.0 to the existing entry. https://github.com/Koenkk/zigbee-herdsman-converters/blob/cba3082d1a9594b4aa74e44d6dccd0ba5d6e1a8b/src/devices/heiman.ts#L599 Here is a external converter, if it works...

Did you try clicking reconfigure after it loads with the new converter?

Also, are you configuring the devices correctly? https://www.zigbee2mqtt.io/devices/HS2IRC.html